A dirty driveway makes a clean house look tired. The Hydro Bros driveway service uses a real surface cleaner, not a hand-held wand, so the concrete or pavers come out evenly clean with no zebra stripes. Oil spots, tire marks, algae, and years of pollen get lifted in one visit, flat rate, no surprises.
What you get with a Hydro Bros driveway clean
- Surface cleaner pass for even, stripe-free results.
- Degreaser pre-treatment on oil and grease stains.
- Algae and mildew killed in shaded and north-facing sections.
- Detail rinse along walls, garage door thresholds, and curb edges.
- Joint check on paver driveways, with a re-sand recommendation if needed.
- Before-and-after photos sent the same day.
Why a surface cleaner matters
A surface cleaner is a flat spinning bar with two or four nozzles inside a shroud. It keeps pressure even across the surface and stops the striping you get when somebody runs a hand-held wand back and forth. On a 600-square-foot driveway that is the difference between a finished, professional look and a blotchy weekend job. Every Hydro Bros driveway gets the surface cleaner pass.
What we wash on every driveway
- Concrete: the most common driveway on Long Island, cleans up dramatically with hot water and a surface cleaner.
- Pavers: surface cleaned, then we check the joints. Re-sanding is recommended after every paver wash to lock the stones back in place.
- Brick: lower-pressure pass to protect the mortar joints.
- Apron and garage threshold: the strip closest to the road and the strip closest to the garage door always get hit hardest.
- Curb and edge details: walked by hand so the clean line stops at the grass cleanly.
What about oil stains
Most fresh and medium-age oil stains lift cleanly with a degreaser pre-treatment followed by hot-water pressure washing. Stains that have been baked in for years may lighten significantly but not fully disappear, and that is the truth on any driveway. We always tell you what to expect before we start so you are not surprised when an old stain ghosts.
The Hydro Bros driveway process
Every clean starts with a walk-around. We mark oil stains, check expansion joints, and pre-wet anything fragile. Then the surface cleaner makes a full pass in even rows, the edges get detailed by hand with a wand, and the whole driveway gets a final rinse so nothing is left to dry into the concrete. A standard two-car driveway is one to two hours. Pavers run longer because the joints need attention.
Long Island neighborhoods we wash every week
Ronkonkoma, Smithtown, Hauppauge, Commack, Huntington, Northport, Stony Brook, Port Jefferson, East Setauket, Selden, Centereach, East Islip, Bohemia, Oakdale, Sayville, Patchogue, Medford, Farmingdale, and Melville. If your block is not listed and you are inside Suffolk or eastern Nassau, ask us anyway. We are usually closer than you think.